You will now be in the “Basic Setup” section of the router. When setting up a router for the first time, refer to the manual and use any installation CDs that come with it. If dd-wrt is already on the router follow these instructions. Manual or Wi-Fi Protected Setup. You can do a factory reset on the unit by powering it off, holding down the reset button with a pen or other pointed object, and holding down for about 15 seconds while you power back on. Set a router password on the Administration tab. You may decide what the Routers IP will be going forward.

Uploader: Mimuro
Date Added: 8 July 2006
File Size: 53.25 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 81019
Price: Free* [*Free Regsitration Required]

This password will be entered to make configuration changes going forward. Support Chart at Bottom. Always do a hard reset prior to flashing another build, then another hard reset after flashing, and NEVER re-use a configuration file from a previous build or another router.

Linksys WRT150N & WRT160N

Can you tell us which parts were out of date so we can update them? If the DD-WRT password change page does not display, your page request times out, or you can’t ping Navigation Main page Menu Recent changes Random page.


Set a router password on the Administration tab. This page was last edited on 24 Liknsysat Usually, you can tell when this process is completed by the WAN light coming on, but it does take several minutes. It is strongly recommended you read and understand all information before making any changes to the listed defaults. See these threads for undocumented recovery means: Go have a beer. You may also forward a range of ports by using the Port Range Forwarding sub-tab.

Done Enabling Memory Writes Barryware, using a mixture of perseverance and brilliance, has found a way to fix the fact that Linksys, in for completely baffling reasons, did not connect the jtag port to the processor.

Retrieved from ” https: Always reconfigure from scratch. Manual or Wi-Fi Protected Setup. This can be used to verify if someone is connected to your router that should not be.

Third party firmware supported: A pass phrase of 22 characters including spaces is recommended. Select “Disable” for Remote Management as you don’t want to be configuring your router from public Internet. Do not flash micro this unit!


Thank you for your feedback! Article Discussion Edit History. You must add the computers that will be restricted by clicking on “Edit List” and adding the computers by IP address, then selecting which day and hour by clicking on the check boxes.

Leave the username blank and enter “admin” for the password.

It’s recommended you choose the strongest encryption method your devices can use. By continuing to use our site, you agree to our cookie policy.

Linksys WRTN Specs – CNET

I needed something I could connect to many times. You should now see the Linksys Management Mode screen. The WRTNv3 differs slightly and has its own instructions further down the page. This article has also been viewedtimes.

Views Read Edit with form Edit View history. What needs to be done, is to bridge the pads on the pcb.